Basic Features - JVC GR-AX827 Manual De Instrucciones

RECORDING

Basic Features

Zoom indicator
Zoom-in
T T T
W W W
Zoom-out
RETAKE
Power zoom switch
START/STOP
VISS
RM-V700U (optional)
FEATURE:
PURPOSE:
OPERATION:
T
W
NOTES:
FEATURE:
PURPOSE:
OPERATION:
NOTE:
FEATURE:
PURPOSE:
OPERATION:
NOTE:
FEATURE:
PURPOSE:
OPERATION:
NOTES:
Zooming
Varies the focal length of the lens and
produces the zoom in/out effect.
Zoom In
1) Pull the power zoom switch down
toward "T".
Zoom Out
2) Push the switch up toward "W".
The further the power zoom switch is
pushed, the faster the zoom speed
becomes.
Focusing may become unstable during
zooming. In this case, set the zoom while
in Record–Standby, set manual focus or
Focus Lock ( pg. 20, 21), then zoom in
or out in Record mode.
Quick Review
To check the end of the last recording.
1) Press " " for less than 2 seconds during
the Record–Standby mode.
• Tape is rewound for about 2 seconds
and played back automatically, then
pauses in Record–Standby mode for the
next shot.
Distortion may occur at start of playback.
This is normal.
Retake
To re-record certain segments.
1) Make sure the camcorder is in the
Record–Standby mode.
2) Press either RETAKE button to reach the
start point for new recording.
3) Press Recording Start/Stop to start
recording.
Noise may appear during Retake.
This is normal.
Index Code Marking
To give you automatic access to any selected
point on a recording. Auto Marking and
Manual Marking are available.
Auto Marking
An index code is always marked to start the
first recording on a new date after a cassette
is inserted.
Manual Marking (Using the optional
RM-V700U Remote Control Unit)
1) Press VISS once to place the index code.
INDEX blinks in the viewfinder during
marking.
If VISS is pressed during
Record–Standby mode, the mark is
placed where START/STOP is pressed.
If the date changes during a recording, it
becomes the first recording of the new
date and an index mark is placed at that
point.
15