Porsche Home Energy Manager Manual Del Usuario página 27

Display phases of the house connection as power
consumers
Instead of listing power consumers here, the indi-
vidual phases of the house connection can also be
added. This allows phase-accurate consumption to
be displayed in the Overview.
Enter the following settings:
1. Select Add power consumer.
2. Enter a name for the fictitious power consumers
(e.g. L1, L2 and L3).
3. Select Single-phase as mains phase.
4. Assign the current converter to the house con-
nection that measures the corresponding phase.
Add EEBus device
b EEBus devices (e.g. chargerPorsche Mobile
Charger Connect, Porsche Mobile Charger Plus)
and energy managers are in the same network.
b EEBus device is turned on and not in standby
mode.
1. Select Add EEBus device.
�� Available EEBus devices are displayed. Only
the devices that are not already connected
to the energy manager are displayed.
2. Select and configure:
The EEBus device can be identified with its iden-
tification number (SKI). The SKI of the charger
Porsche Mobile Charger Connect can be found in
the Web Application of the charger (Connections
e Energy manager).
Information
Deactivate the standby mode of the charger Porsche
Mobile Charger Connect in the Web Application of
the charger.
Option Explanation
Name Name of the power consumer
Type Preset as EEBus device
Mains Specification of the number of
phases phases in the supply cable for the
EEBus device
Assign cur- Select the current converter that
rent sensor is connected to the line to the EE-
to a phase. Bus device
e
Start the connection to the charger.
–
ChargerPorsche Mobile Charger Connect:
Start the EEBus pairing in the Web Applica-
tion of the charger (Connections e Energy
manager) or on the charger (Settings e En-
ergy manager).
– ChargerPorsche Mobile Charger Plus: Acti-
vate the charging status Energy manager
on the device. The device automatically at-
tempts to connect to the PLC network and
the energy manager.
e
Information on adding the energy manager to
Web Application of the charger can be found in
the Owner's Manual on the Porsche website at
the following address:
https://tinyurl.com/porsche-e-help
Information
Observe the possible phase distortion of the socket
to which the charger is connected.
Start first installation
Example:
An EEBus device should be connected to a phase-
turned socket that does not use phase 1 as usual,
but phase 2 or is multiphase and does not start with
phase 1, but with phase 2.
The current converter assigned to phase 2 is selected
as the first current converter in a phase. The current
converter is thus assigned to the line to the EEBus
device.
Note: Without an EEBus coupling on both sides with
a charger like the Porsche Mobile Charger Connect,
the Optimized charging function cannot be used.
You can also see a successful pairing by the symbol
Energy manager connected (house symbol) in the
status bar of the charger.
Information
Phase-specific throttling
Porsche Vehicles supplied with energy managers can
restrict the charging current in a phase-specific man-
ner. The chargers should therefore always be config-
ured to the correct phase, otherwise the charging
process will be throttled to the wrong phase.
Information
Overload protection always protects the fuse on the
line where the current converter configured for the
EEBus device is located and the main fuse.
If no additional current converters are available at the
place of use, the house connection current converters
can be used to measure the EEBus device.
Additional current converters are available as spare
parts from your authorized Porsche dealer.
25