Hot Restart - Maruyama B420L Manual Del Propietario U Operador

Fast-idle Start Lock
STOP (OFF)
Stop Switch
2. Move the choke lever to the closed (
and move the stop switch to the "START" (ON)
position.
3. Lock the throttle trigger in the fast-idle start
position, then pull the starter grip.
4. After the engine starts, squeeze and release the
throttle trigger to return it to the idle position, then
move the choke lever to the open (
WARNING
POTENTIAL HAZARD
• The components of your recoilstarter
assembly are under high spring tension. If
improperly disassembled these parts
maystrike you with considerable force,
possibly causing personal injury.
WHAT CAN HAPPEN
• Contact with the parts can cause severe
personal injury.
HOW TO AVOID THE HAZARD
• Never attempt to disassemble your recoil
starter assembly yourself. Always consult
your authorized MARUYAMA dealer for
repair by qualified service technicians.
CAUTION
• Do not pull the Starter rope all the way out.
If the engine stops running before you move the
choke lever to the open (
Go ahead and open the choke, pull the starter grip with
the throttle trigger positioned at Fast-idle position.
START (ON)
Fast-idle Start
Position
Idle Position
) position
) position.
) position:

Hot Restart

To start an engine that is already warmed up (hot restart),
or if the ambient temperature exceeds 68°F (20°C):
1. Pump the primer bulb until fuel can be seen
flowing through the fuel return line to the fuel
tank. (Flowing fuel should be almost clear, not
foamy or full of bubbles.)
2. Move the choke lever to the open (
and move the stop switch to the "START" (ON)
position.
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (US-15).
If the engine fails to start after you follow the
above procedu res, contact an author ized
MARUYAMA dealer.
To Stop The Engine:
1. Release the throttle trigger.
2. Slide the stop switch to the "STOP" (OFF)
position.
Fast-idle Start Lock
STOP (OFF)
Stop Switch
— US-16 —
) position
START (ON)
Fast-idle Start
Position
Idle Position