Cameo ZENIT W300 TW Manual De Usuario página 21

Use the UP and DOWN controls to select the desired submenu item, and press ENTER to display
the corresponding information.
System Info
Displays
Firmware =
Device Firmware
Temperature display
Temperature =
LED unit
Operation Displays operating
=
Hours time
MANUAL LOCKING FUNCTION
In addition to the ability to automatically protect the spotlight from accidental and unauthorised
operation (see „Settings" - „Auto-lock"), the controls can also be locked manually. Press and hold
the UP and DOWN controls simultaneously for approximately 5 seconds. If an attempt is made to
change settings, „Locked!" will appear in the display, and changing the spotlight's settings via
the controls is no longer possible. After approx. 1 minute, the current operating mode is displayed
again. To unlock, press and hold the UP and DOWN controls simultaneously for approximately 5
seconds. The display will show the previously displayed information.
SETUP AND INSTALLATION
HAZARD: Overhead mounting requires extensive experience, including the calcula-
tion of the load limit values of the installation material and regular safety inspection
of all installation materials and spotlights. If you do not have these qualifications, do
not attempt to perform an installation yourself. Refer instead to a qualified professio-
nal. There is a risk that devices that are incorrectly mounted and secured may come
loose and fall down. This can cause serious injury or death.
Thanks to its integrated plastic feet, the spotlight can be positioned in a suitable location on a
level surface. It can also be mounted on a traverse using an Omega bracket, which is attached in
the centre of the base (1). An Omega bracket is included in the packaging content. Suitable beam
clamps are available as an option. Ensure firm connections and secure the spotlight to the secu-
ring lug (2) with a suitable safety cable. To adjust the beam angle of the LED unit independently of
the base of the device, use the thumb screws on the sides.
Main CPU Vx.xx
LED
Vx.xx
Driver
LED xx °C / xx °F
°C (= display in degrees Celsius)
Unit
°F (= display in degrees Fahrenheit)
Displays total operating time in hours and
xx:xx h
minutes
21