Corghi EYELIGHT Plus Diagnostic Line Manual De Uso página 55

radial run-out acquisition of the complete wheel
and rim
• in addition to the acquisitions descri-
bed in the previous methods
outboard side of the rim is detected, the height
of the tread and any wheel drift is measured
By checking this FLAG, the machine cycle time
increases as data regarding the geometry of the
wheel being examined is acquired.
MAIN CONTROL KEYPAD
The main control keypad has the following buttons:
1.
Help button
- recalls information on the current video page
to the screen. If an error message is displayed,
the first piece of information displayed refers
to the error list. The instructions called up by
this icon integrate (but do not replace) this User
Manual.
2.
Automatic dimensions button
- This enables automatic dimension measure-
ment after which the icon is disabled at the end
of the balancing cycle (ie. dimension reading is
not repeated until the button is re-enabled).
- This displays the page for manual entry of
dimensions if the laser sensors have been
disabled (see the "Wheel balancer parameter
configuration" section).
3.
Utility and configuration menu button
- This groups all the machine Utility and Configu-
ration programmes.
4.
EYELIGHT Plus DiagnosticLine - Operator's manual
Live button
- This is used to check and/or modify the balanc-
ing planes measured by the processing unit.
5.
Start button
- This starts the unbalance measurement cycle
when the guard is lowered.
the
6.
Stop button
- This stops the wheel for 50 seconds to allow
wheel mounting/demounting or weight applica-
tion.
- If held down for 3 seconds, it activates the C
hub demounting procedure and displays the
A 52 message.
- Interrupts the unbalance measuring cycle.
- Raises the wheel guard (L, Fig. 8) and interrupts
the unbalance measurement cycle.
SECONDARY CONTROL
The secondary control keypad can be used to
quickly modify machine status and consists of
the following five buttons:
1.
enables/disables the Weight Management
suite:
- Select this button to activate the Less Weight
programme for weight saving consisting of two
balancing modes:
optimised mode for fast vehicle wheels;
or
wheels;
press the button again to deactivate the Weight
Management suite.
Wheel balancing is performed using the de-
sired balancing programme. At the end of the
spin, if wheel balancing is considered satisfac-
tory, the position indicators will display the
icons and two semicircular indicators for
KEYPAD
optimised mode for slow vehicle
UK
55