Corghi EYELIGHT Plus Diagnostic Line Manual De Uso página 67

2. MANUAL ENTRY OF WHEEL DIMENSIONS
In the event of failure of the internal and/or ex-
ternal laser sensors or incorrect measurement
of one of the three working dimensions, the
geometric data can be entered manually using
the following procedure.
A screen is displayed with the default or previ-
ously measured wheel dimensions.
Using the number pad, one or more of the wheel
dimensions can be changed.
- The wheel balancer prepares for manual entry
of the distance.
- Using the number pad, change the distance
displayed by entering the distance measured
with a tape measure between the right edge
of the body and the inner edge of the rim (Fig.
18).
- press the button
confirm and then enter the width value
- Change the displayed value to the value
measured using the manual calliper (Fig. 19).
EYELIGHT Plus DiagnosticLine - Operator's manual
-
-
-
Note: When dimensions are set manually, clip
or adhesive weights must be applied manually
in the 12 o'clock position.
18
3. Suite WHEEL DIAGNOSIS PROGRAMME
3.1. Radial and lateral runout measurement
This function is used to determine the causes of
disturbance (vibration) generated by geometric
deformation of the rim and/or tyre, which may
on the monitor to
still persist even after a thorough balancing
procedure.The machine indicates that the pro-
cedure needs to be performed by displaying the
following war-ning light
can decide to perform the procedure whenever
considered necessary.
To do this, perform a spin.
If a wheel assembly is mounted, the following
icons are displayed on the screen at the end of
the spin indicating:
press the button
confirm and then enter the diameter value;
Change the value of the diameter displayed
by entering the value indicated on the tyre
using the keypad.
Press the Exit
the manual data setting.
19
on the monitor to
button to terminate
UK
. The operator
67