Wheel Spin And Automatic Dimension Measurement - Corghi EYELIGHT Plus Diagnostic Line Manual De Uso

ognises the WINUT device;
- : indicates that the battery in the sleeve
C is charged;
- : indicates that the battery in the sleeve
C is at roughly the halfway point of its charge
level;
- : indicates that the battery in the sleeve
C needs to be replaced.
To replace the battery in the sleeve C, proceed
as follows:
- Open the sleeve C by loosening the six M3
fixing screws (Fig.14b);
- - Remove the card inside it (Fig.14c);
- Replace the battery in the sleeve C with a new
CR2450 3V;
- Assemble the sleeve C, following the disas-
sembly instructions in reverse order.
EYELIGHT Plus DiagnosticLine - Operator's manual
WHEEL SPIN AND
AUTOMATIC DIMENSION
Wheel spin takes place automatically by lowering
the guard or pressing the Start button
with the guard lowered. The wheel protection
lock is manual, while the opening of the wheel
is automatic. The following graphic appears on
the screen to alert the operator of the imminent
opening of the wheel guard:
14b
A special safety device stops rotation if the guard
is raised during the spin; in this case, the A Cr.
message is displayed.
During the spin, the wheel balancer lights up the
inner part of the rim and displays on the screen
the assembled wheel by way of a telecamera.
Using a special software, the image of the wheel
is acquired and processed to allow the laser sen-
sors to measure the dimensions of the rim for the
final calculation of the unbalances.
At the end of the spin, if the AUTOWS function is
selected, the machine automatically suggests the
optimum balancing programme (DYN, ALU1 or
ALU2) in relation to the characteristics of the rim.
At the end of the spin, the rated dimensions of
14c
the wheel are displayed in the feedback window,
specifically:
- The nominal rim width (only for dyn, sta, alu3,
alu4 and alu5 programs).
- The nominal rim diameter.
- The distance from the body to the inner edge
of the rim.
Note: at the end of the spin, if the automatic
position search function is enabled, the wheel
MEASUREMENT
UK
59