Shutting Down; Using The Automatic Wheel Clamping System C - Corghi EYELIGHT Plus Diagnostic Line Manual De Uso

After pressing the button, the following im-
age
while the file is being saved to the USB key.
When the image disappears, you can remove
the USB key from the machine.
The file is saved to the USB key with a unique
file name, consisting of the total count of spins
performed by the machine (e.g. 000014) and,
if required, a custom file name entered by the
operator (customer name or vehicle license
plate number).
By pressing the network button
you can save the report of the measurements
made in .pdf format to a network directory.
FEEDBACK WINDOW
The feedback window, as shown in the figure
below, displays the following information:
- Name of operator (see the "Customisation"
section).
- Time (see "Wheel balancer parameter con-
figuration" section).
- Wheel dimensions during the last spin: white
if measured automatically; or yellow if set
manually.
- enabling the WM programme.
- the parking brake status (enabled or not
enabled).

SHUTTING DOWN

EYELIGHT Plus DiagnosticLine - Operator's manual
appears on the screen
This function starts the shutdown process which
protects the Windows operating system installed
on the PC and depowers the machine.
Proceed as follows:
Press the Enter button
-
- Wait for the PC to be turned off completely
as confirmed by an intermittent beep.
- finally, press the switch located on the left
side of the casing (B, fig.11b).
USING THE AUTOMATIC
WHEEL CLAMPING
SYSTEM C
NOTE:
After every power on, the first time the automatic
wheel clamping system is activated using the
pedal, the machine will perform a calibration by
automatically moving the two ratchets located on
the hub towards the outer side. When calibration
is complete, the operator can use the machine
as described below.
Wheel locking procedure with the automatic C:
Centring with cone at front
- Fit the wheel on the shaft, sliding it into place
until it rests against the flange.
- Fit the most suitable cone on the shaft and
insert it into the central hole of the wheel.
- Fit the locking device by making it slide on
the hub until it comes into contact with the
cone.
- Press the control pedal for at least one second.
Centring with cone at rear
- Fit the most suitable cone for the central hole
of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into
place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on
the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second
to release the wheel from the flange.
Centring with flanges
C hub removal
.
UK
57