Workpiece Clamp; Dust Extraction; Adjusting The Table Extension; Workpiece Stop - Festool KAPEX KS120 REB Manual De Instrucciones

8.3

Workpiece clamp

8.2
8
Fitting the workpiece clamp
► Fit the workpiece clamp [8.1] into one of the
two holes [8.2]. The clamping unit must
point towards the rear.
► Twist the workpiece clamp so that the
clamping unit faces forward.
8.4

Dust extraction

WARNING
Health hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
► Wear a dust mask.
9.1
9a
A Festool dust extractor with an extractor hose
diameter of 1-7/16" or 1-16" (36 mm or 27 mm).
(1-7/16" (36 mm) recommended due to the re­
duced risk of clogging) can be connected to the
extractor connector [9.1].
8.1
9.2
The flexible chip deflector [9.2] improves the
collection of dust and chips. Therefore, never
work without a fitted chip deflector.
9b
The chip deflector is clamped in position on the
guard with the clamp [9.3]. For this, the
hooks [9.4] of the clamp must lock into the re­
cesses [9.5] of the guard.
8.5

Adjusting the table extension

► Open the knob [1.9].
► Pull out the table extension [1.8] far enough
that the workpiece is laid out fully.
► Close the rotary knob.
If, despite the table extension being
extended as far as possible, the work­
piece protrudes over the table, the
workpiece must be supported by oth­
er means.
8.6

Workpiece stop

10.1
10
Adjusting the stop ruler
For mitre cuts, you must adjust the stop rul­
ers [10.1] so that they do not impede the func­
tionality of the pendulum guard or come into
contact with the saw blade.
► Open the clamping lever [10.2].
English
9.3 9.4 9.5
10.2
10.3
15