Service And Maintenance; Adjusting The Laser - Festool KAPEX KS120 REB Manual De Instrucciones

19.1
19

10 Service and maintenance

WARNING
Any maintenance or repair work that re­
quires opening of the motor or gear housing
should only be carried out by an authorised
Customer Service Centre (name supplied by
your dealer)!
► Maintenance or repair work carried out by
an unauthorised person can lead to the
wrong connection of the power cord or oth­
er components, which in turn can lead to
accidents with serious consequences.
CAUTION
Certain cleaning agents and solvents are
harmful to plastic parts.
► Some of these include, but are not limited
to: Gasoline, Acetone, Methyl Ethyl Ketone
(MEK), Carbonyl Chloride, cleaning solu­
tions containing Chlorine, Ammonia, and
household cleaners containing Ammonia.
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
► Regularly clean the table top insert [20.1]
as well as the extraction channel of the chip
deflector [20.2] by blowing out with com­
pressed air or using a brush to remove
wood chips, dust deposits and remains of
workpieces.
20.1
20
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
The tool is equipped with special self-discon­
necting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festoolusa.com/service
Always use original Festool
EKAT
spare parts. Order no. at:
4
www.festoolusa.com/service
5
3
2
1

10.1 Adjusting the laser

The laser beam has been set correct­
ly during manufacture. Only turn the
adjusting screws out of position in the
cases that are specified.
If the laser beams do not align with the cutting
edge, you can readjust the two lasers. Use a
screwdriver (3/32" (2.5 mm) width) to do this.
► Pierce the adhesive labels at the marked lo­
cations ([21.1] to [21.6]) with the screwdriv­
er to access the adjusting screws under­
neath.
► Insert a sample workpiece into the machine
to check the laser.
► Saw a groove into the workpiece.
► Swivel the head of the saw upward and
check the setting.
English
20.2
21