Intended Use; Specifications; Parts Of The Machine - Festool KAPEX KS120 REB Manual De Instrucciones

The risk from these exposures varies, depend­
ing on how often you do this type of work. To re­
duce your exposure to these chemicals: work in
a well ventilated area, and work with approved
safety equipment, such as dust masks that are
specially designed to filter out microscopic par­
ticles. Wash hands after handling.
WARNING
TO REDUCE THE RISK OF INJURY, USER
MUST READ INSTRUCTION MANUAL.
4

Intended use

The power tool is a stationary unit designed for
sawing blocks of wood, plastic, aluminium pro­
files and similar materials. Do not use it to
process other materials, in particular steel,
concrete and mineral materials.
Only use Festool saw blades that are designed
for use in this power tool.
The saw blades must comply with the following
data:
– Saw blade diameter 10-1/4" (260 mm)
– Cutting width 3/32" (2.5 mm) (corresponds
to the tooth width)
– Locating bore 1-3/16" (30 mm)
– Standard blade thickness 1/16" (1.8 mm)
– Saw blade in accordance with EN 847-1
– Saw blade with chip angle ≤ 0°
Festool saw blades for woodworking comply
with EN 847-1.
Only saw materials for which the relevant saw
blade has been designed.
This power tool may only be used by experts or
instructed persons.
The user is liable for damage and acci­
dents caused by improper and non-in­
tended use.
5

Specifications

Mitre saw
Performance
Speed (idle)
Tool spindle dia.
KS 120 REB
13 A
1400–3600 rpm
1-3/16" (30 mm)
Mitre saw
Weight according to EP­
TA-Procedure 01:2014
For maximum workpiece dimensions see the
section on Working with the power tool.
6

Parts of the machine

[1.1] Handle
[1.2]
On/off switch
[1.3] Safety lock
[1.4]
Cutting depth limiter lever
[1.5] Rotary knob for clamping the pulling
unit
[1.6]
Transport lock
[1.7] Scale for mitre angle (vertical)
[1.8]
Extension table
[1.9] Rotary knob for extension table
[1.10] Scale for mitre angle (horizontal)
[1.11] Clamping lever for mitre angle (hori­
zontal)
[1.12] Notch lever for preset mitre angle
(horizontal)
[1.13] Pendulum guard
[1.14] Rotary handle for precision adjust­
ment of mitre angle (vertical)
[2.1] On/off switch for laser
[2.2]
Speed adjusting wheel
[2.3] FastFix spindle stop
[2.4] Clamping lever for stop ruler
[2.5] Bevel holder
[2.6] Release lever for special cutting posi­
tion
[2.7] Lever for special cutting position
[2.8] Cable winder with integral carry han­
dle
[2.9] Clamping lever for mitre angle (verti­
cal)
[2.10] Selector switch for mitre angle range
(vertical)
The pictures for the functional description are
on a fold-out page at the beginning of the in­
struction manual. While reading the manual
English
KS 120 REB
52 lb. (24 kg)
11