Tripp-Lite APSWX Serie Manual De Instrucciones página 19

4. Operation
Program Code Function
AC + Solar
13 Total Charging
Current
Setting Voltage
Point to Battery
Mode
14 When Selecting
"SBU Priority" or
"PUL Priority" in
Program 01
Discharge Limited
15
Current
Lithium Battery
16 Discharge Stop
(Factory Use Only)
Lithium Battery
17 Charge Stop
(Factory Use Only)
Selectable Options Description
60A (Default)
The setting range is 10A to 90A adjusted in increments
of 10A.
48V model default
48V model: 54.0V DC (default)
setting: 54.0V DC
Setting range: 40V to 58V
Setting with increase or decrease of 0.1V.
OFF: Default; discharge current limited disable.
Setting range: 10A to 200A setting increase or decrease
of 5A.
Notes:
• If operating in "PV priority mode" or "SBU priority mode",
• Discharge limit current only works in battery mode when the
Default: 6%
When the battery capacity of the lithium battery is lower
than the set point, the inverter stops discharging and
output will turn off.
Setting range: 1% to 60%, setting increase or decrease
of 1%.
Default: 96%
When the battery capacity of the lithium battery is higher
than the set point, the inverter stops charging.
Setting range: 60% to 100%, setting increase or
decrease of 1%.
19
when the load is greater than the current limiting point, it will
automatically switch to utility mode.
load is greater than the current limiting point. The inverter will
shut down immediately.