Publicidad
Idiomas disponibles
Idiomas disponibles
Comply with the maximum load-bearing capacity.
3.3.4.
Casing
Size 200 to 500 and 800 to 900 for installation on a GridLine Vario workbench.
For installation up to and including size 500 in conjunction with a support leg.
From size 800 the casing replaces the support leg. Select the height to correspond to the opposite support leg or cas-
ing.
Comply with the maximum load-bearing capacity.
Drawers for storage of tools.
Storage shelf for storage of workpieces and tools.
Mount only on suitable holes.
3.4.
IMPROPER USE
Do not place or position on the workbench. Not for transporting people.
Not for use in areas where the floor slopes upwards or downwards.
Do not use in potentially explosive atmospheres.
No do expose it to water, precipitation or contamination.
Not for use in areas where the floor is loose or unpaved.
Do not overload the workbench, worktop, drawers or storage shelves.
Do not carry out any unauthorised modifications.
3.5.
PERSONNEL QUALIFICATIONS
Specialists for mechanical work
Specialists in the sense of this documentation are persons who are familiar with assembly work, mechanical installation,
commissioning, troubleshooting and maintenance of the products and who possess the following qualifications:
Qualification / training in the field of mechanics as specified in the nationally applicable regulations.
Trained person
Trained persons in the sense of this documentation are persons who have been trained to perform work in the areas of
transport, storage and operation.
3.6.
PERSONAL PROTECTIVE EQUIPMENT
Comply with the national and regional regulations for safety and accident prevention. Protective equipment such as safety
shoes and safety gloves appropriate for the risks associated with the intended activities must be selected, provided and
worn.
3.7.
DUTIES OF THE OPERATING COMPANY
Ensure that all of the works listed below are carried out by qualified specialist personnel:
Transport and installation location
Installation
Maintenance
The operating company must ensure that personnel who work on the product comply with the regulations and provisions
together with the following instructions:
National and regional regulations for safety, accident prevention and environmental protection regulations.
No damaged products are assembled, installed or commissioned.
The necessary protective equipment is provided.
4.
Transport and place of erection
i
Immediately on receipt check the product for damage in transport. If the product is damaged, do not install or commission
it.
CAUTION
Improper transport to the place of erection
The workbench has a high tare weight - risk of injury if lifted improperly.
»
Wear foot protection and safety gloves.
»
Make sure the paths for movement and transport are clear.
»
At least two persons must be employed to transport the workbench to the erection location.
»
Ensure during movement and transport that all drawers and cupboard doors are closed and locked.
Make sure that no components are damaged or destroyed during transport and handling.
www.hoffmann-group.com
de
bg
da
en
fi
fr
it
hr
lt
nl
no
pl
pt
ro
sv
sk
sl
es
cs
hu
31
Publicidad
