Garant GRIDLINE 922001 Manual De Instrucciones página 32

GARANT Vario workbench
de
NOTICE
Improper transport
bg
Damage due to improper transport.
» Use only suitable lifting gear for transporting the workbench to the erection location.
» Do not attach lifting gear to the worktop in order to lift the workbench.
da
» Do not pull the workbench across the floor.
» Keep the workbench horizontal during transport.
» Put the workbench down gently.
en
5. Installation instructions
Trained specialist for mechanical work
fi
5.1. ACCESSORIES
fr
When installing additional accessories, observe the relevant installation instructions.
6. Installing the support leg and stabilising plates
it
i
Two persons working together turn the worktop over and place it on a flat and clean support surface.
hr
6.1. SCOPE OF SUPPLY
Support leg
lt
 1 pc. support leg
 3 pcs. hex wood screw Ø8 x 32 mm
nl
 3 pcs. washer Ø 8.4 mm
Stabilising plate
no
 2 pcs. stabilising plate
 4 pcs. hex wood screw
 4 pcs. M6x12 hex screw
pl
 4 pcs. washer
 4 pcs. cage nut
pt
6.2. SUPPORT LEG
A
1. Secure each support leg to the worktop using three Ø8.4 washers and Ø8×32 woodscrews, using the pre-drilled holes.
ro
2. For workbenches without a casing standing on the floor: Repeat for the second support leg.
6.3. STABILISING PLATE
sv
6.3.1. Use cage nuts
B
sk
i
For each stabilising plate, install two cage nuts at the head end of the leg in the punched holes.
1. Insert the cage nuts into the punched recess obliquely from the front.
sl
2. Use a screwdriver to push them back and clip them securely into position.
6.3.2. Installing a single stabilising plate
C
es
 Does not need to be installed if installing the rear panel or installing the drawer casing.
1. Secure the stabilising plate using two M6×12 hex screws and cage nuts.
cs
2. Secure the stabilising plate to the worktop using two Ø8.4 washers and Ø8×32 wood screws.
7. Installing the rear panel and storage shelf
i
hu
When installed as a rear panel, no stabilising plate is necessary.
32