Garant GRIDLINE 922001 Manual De Instrucciones página 34

GARANT Vario workbench
de
2. Only for casing size 200 to 500: Screw M6×10 mm raised-head self-tapping screws into the cage nuts in the support leg.
3. Screw the casing to the worktop using four washers and four Ø 8×32 mm hex screws.
8.5. INSERTING THE DRAWERS
bg
I
1. Pull out the pull-out rails and secure them.
da
2. Insert the drawer and push it in until you sense resistance.
3. Lift the drawer up and push it over the resistance until it is fully inserted on the rails.
4. Swing the locking mechanism down and push it to the back.
en
9. Setting up the workbench
9.1. SET-UP
fi
ü At least 2 persons must be employed to transport the workbench to the set-up location.
ü Ensure there is a solid, level floor suitable for the maximum load capacity of the workbench.
1. Set up the workbench on a level and solid floor.
fr
2. Use a spirit level to check whether the workbench is horizontal and perpendicular.
» Position the workbench in the set-up location.
9.2. ANCHORING
it
WARNING
Workbench tipping over
hr
Risk of injury
Risk of tipping over, when workbench weighs <150 kg and the loading per drawer is >35 kg.
» Anchor the workbench to the floor.
lt
NOTICE
Wiring and pipes installed in the floor
nl
Damage to wiring and pipes.
» Check floor for sufficient load-bearing capacity before drilling.
» Use suitable drill and drilling materials.
no
» Use suitable protective equipment.
» Drilling to be carried out by trained personnel.
» Do not drill in the immediate vicinity of wiring or pipes.
pl
10. Storage
 Storage temperature between -10°C and +60°C.
pt
 Store in an enclosed dry room.
 Atmospheric humidity: 90 %, non-condensing.
11. Maintenance
ro
Do not use alcoholic, abrasive or solvent-based cleaning agents.
Interval
sv
Before each occasion of use
Monthly
sk
sl
If the workbench is dirty
es
In the event of damage to
the workbench, components
cs
and accessories
12. Spare parts
hu
Order original spare parts from the Hoffmann Group Customer Service.
34
Maintenance work
Check workbench for external damage.
Check all components and screw fastenings on the work-
bench for tightness and operation.
Remove external dust and dirt.
Check for damage and cracks.
Clean the side panels, metal fronts, drawers and feet with
paint cleaner.
Clean the worktop with a damp cloth.
Block access to the workbench and prevent its use.
Have damaged components and accessories replaced im-
mediately.
Performed by
Trained person
Trained person
Trained person
Trained specialist for mechan-
ical work