Garant GRIDLINE 922001 Manual De Instrucciones página 33

7.1. SCOPE OF SUPPLY
Single-piece
 1 pc. rear panel / storage shelf
 4 pcs. M6 hex screw
 4 pcs. cage nut
Two-piece
 2 pcs. rear panel / storage shelf
 8 pcs. M6 hex screw
 8 pcs. cage nut
7.2. USE CAGE NUTS
B
i
For each rear panel: At the top end or foot end of each support leg, install two cage nuts on the inside punched recess.
For each storage shelf: At the lower cross brace of each support leg, install two cage nuts on the inside punched recess.
1. Insert the cage nuts into the punched recess obliquely from the front.
2. Use a screwdriver to push them back and clip them securely into position.
7.3. REAR PANEL / STORAGE SHELF
D E
/
i
Install the rear panel at the rear of the workbench.
Install the storage shelf in lower cross brace of each support leg.
 During installation, leave the punched recesses for the cable ducts clear.
 Secure the rear panel/support shelf to each support foot with two M6 hex-head screws with cage nuts.
8. Installing the casing
i
Casing for installation on the left side or right side.
8.1. SCOPE OF SUPPLY
 1 pc. casing
 4 pcs. hex wood screw Ø 8 x 32 mm
 4 pcs. washer
 2 pcs. M6 x 10 round-head screw
 2 pcs. cage nut
8.2. REMOVING THE DRAWERS
F
1. Pull out the drawer.
2. Pull out the locking mechanism and swing it upwards. Remove the drawer.
8.3. USE CAGE NUTS
B
i
Applies only to a suspended casing. Fit two cage nuts at the head end of the front leg into the punched holes on the inside.
1. Insert the cage nuts into the punched recess obliquely from the front.
2. Use a screwdriver to push them back and clip them securely into position.
8.4. INSTALLING THE CASING
G H
/
i
Two persons working together turn the worktop over and place it on a flat and clean support surface.
Install the casing on the worktop according to the hole pattern.
1. Remove the drawers (see Removing the drawers) or open the door.
www.hoffmann-group.com
de
bg
da
en
fi
fr
it
hr
lt
nl
no
pl
pt
ro
sv
sk
sl
es
cs
hu
33