Set Volume; Delete Data - Hilti PS 200 Manual De Instrucciones

Settings – Sets various parameters and deletes all scans
held in memory.
en
7.2.4 Settings
Use this menu to set general parameters and to delete
scans from the scanner that have not been transferred
to the monitor.
Upon entering Settings, the following screen is dis-
played:
Use the Arrow buttons to toggle between options, Con-
firm to select an option and Cancel to return to the main
menu.
7.2.4.1 Set display backlight
Sets the display backlight. Use the Arrow buttons to tog-
gle between options. Use the Confirm button to select
the desired option and then press the Cancel button to
return to the settings menu.
Backlight permanently on
Backlight permanently off
46
Printed: 07.07.2013 | Doc-Nr: PUB / 5070389 / 000 / 00
Backlight timed – switches off 5 minutes after the last
press of a button. Backlight activates automatically on
next press of a button.

7.2.4.2 Set volume

Sets the volume level of the audible signal during scan-
ning. Use the Arrow buttons to toggle between options.
Use the Confirm button to select the desired option and
then press the Cancel button to return to the settings
menu.
7.2.4.3 Set units
Sets the units used during measurement. This is avail-
able only in units with item no. 377642. Use the Arrow
buttons to toggle between options. Use the Confirm but-
ton to select the desired option and then press the Can-
cel button to return to the Settings menu.
metric (mm or m, as appropriate)
imperial (inches or feet, as appropriate)

7.2.4.4 Delete data

Deletes all data contained in the scanner. This function
can be accessed only if data is contained in memory. If
data is contained in memory, the bar that appears next