About This Documentation - Aventics AS1 Instrucciones De Servicio

AVENTICS | AS1 / AS2 / AS3 / AS5 | R412013438–BAL–001–AD | English
English
1

About this documentation

These instructions contain important information for
the safe and appropriate assembly and commissioning
of the product.
O Read these instructions carefully, especially
the section "Notes on Safety", before working
with the product.
Additional documentation
O Also follow the instructions for the other system
components.
O Furthermore, observe general, statutory and other
binding rules of the European and national laws, as
well as the valid regulations in your country to protect
the environment and avoid accidents.
Presentation of information
Safety instructions
In this document, there are safety instructions before
the steps whenever there is a danger of personal injury
or damage to the equipment. The measures described
to avoid these hazards must be followed.
Structure of warnings
Type and source of risk
Consequences of non-observance
O Measures to avoid these hazards
Meaning of the signal words
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Symbols
Operation may be impaired if this information
is disregarded.
SIGNAL WORD
CAUTION
2 Notes on Safety
The product has been manufactured according to the
accepted rules of current technology. Even so, there
is a risk of injury or damage if the following general
safety instructions and the specific warnings given
in this instruction manual are not observed.
O Read these instructions completely before working
with the product.
O Keep these instructions in a location where they are
accessible to all users at all times.
O Always include the operating instructions when you
pass the product on to third parties.
Intended use
The product is exclusively intended for installation
in a machine or system or for combination with other
components to form a machine or system. The product
may only be commissioned after it has been installed
in the machine/system for which it is intended.
Use is permitted only under the operating conditions and
within the performance limits listed in the technical data.
Only use compressed air as the medium.
The product is technical equipment and is intended
for professional use only.
Intended use includes having read and understood
this documentation, especially the chapter "Notes on
Safety".
Personnel qualifications
All tasks associated with the product require basic
mechanical, pneumatic and electrical knowledge, as well
as knowledge of the respective technical terms. In order to
ensure operational safety, these tasks may only be carried
out by qualified personnel or an instructed person under
the direction of qualified personnel.
Qualified personnel are those who can recognize possible
hazards and institute the appropriate safety measures,
due to their professional training, knowledge, and
experience, as well as their understanding of the relevant
regulations pertaining to the work to be done. Qualified
personnel must observe the rules relevant to the subject
area.
6