Britax Poplar S Guia Del Usuario página 25

7. Close the ClickTight
over the vehicle belt.
8. Ensure both gray
ClickTight release
buttons are visible.
NOTE:
If it is difficult
to close
have removed
much slack.
Rear-Facing Installation with Lap-Shoulder Belt
Without Stability Bar
9 Recline indicator is still within the correct section for
rear-facing, after child is secured.
9 Child restraint cannot be moved front to back or side
to side more than 1" (2.5 cm) at the belt path.
9 Both vehicle lap and shoulder belts are routed
through ClickTight.
9 Car seat base MUST be flat on vehicle seat and MUST
be parallel to vehicle seat.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
you may
too
7
8
With Stability Bar
23