Publicidad
Idiomas disponibles
Idiomas disponibles
Lap Belt Only (Type 1) Installation
IMPORTANT:
your vehicle owner's manual.
Remove the tether.
1.
a. Extend the tether by
lifting on the tether
adjuster.
b. Unhook the tether
hook from the back
of the child restraint
and place it over the
seat back.
Pos i tion child restraint on
2.
the most upright position.
a. Locate the white
dashed line on
either side of the
base.
b. Recline the seat
towards the white
dashed line.
IMPORTANT:
white dashed line is NOT
visible.
Place child restraint
3.
forward-facing.
a. Push child restraint
into vehicle seat
bight to position
base flat on the
vehicle seat.
NOTE: Ensure that no
more than 3" (7.5 cm) of
the base hangs over the
edge of the vehicle seat
(see page 12).
b. NOTE: Make sure
the recline indicator
ball is completely
within the dashed
green lines.
Open the ClickTight.
4.
a. Lift the front cover
flap.
b. Squeeze the
ClickTight release
buttons.
Vehicle belt MUST be locked according to
Make sure the
1b
2a
2b
3a
3b
4
b
3"
a
33
Publicidad
