Publicidad
Idiomas disponibles
Idiomas disponibles
6. Lock and remove slack
from the vehicle belt.
NOTE: Make sure that
the vehicle belt is
locked as directed by
your vehicle owner's
manual.
Close the ClickTight
7.
over the vehicle belt.
8. Ensure
both gray
ClickTight release
buttons are visible.
NOTE: If it is difficult to
close you may have
removed too much
slack.
Rear-Facing Installation with Lap Belt
Without Stability Bar
9 Recline indicator is still within the correct section for
rear-facing, after child is secured.
9 Child restraint cannot be moved front to back or
side to side more than 1" (2.5 cm) at the belt path.
9 Lap Belt is routed through the ClickTight.
9 Car seat base MUST be flat on vehicle seat and
MUST be parallel to vehicle seat.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
6
7
8
With Stability Bar
27
Publicidad
