Publicidad
Idiomas disponibles
Idiomas disponibles
For continuous
documentation
of longer events, the GR-C7E
can be used as an independent video camera
in
combination with either a deck-type or portable video recorder.
®Connect the AV OUT connector
of the GR-C7E to the AUDIO IN and VIDEO IN connectors of the video re-
corder using either of the provided dubbing cables, depending on the deck you are using.
|
Dubbing cable with 21-pin
| connector (provided)
Note:
ein this configuration, it is possible to obtain a con-
tinuous recording and an edited-out recording of the
same
event simultaneously, because the GR-C7E's
start/stop button only controls the tape inside itself
Operation
1. Press the MONITOR button. The
camera output signal is now avail-
able via the dubbing cable.
2. Put the connected
recorder
in
the
Record
mode.
Recording
will start. Tape start/stop should
be controlled with the recorder's
buttons.
To AV OUT
connector
while another tape loaded in the connected recorder
continues running. To record on the GR-C7E's tape,
follow the same recording procedure as mentioned
before.
press REC STBY
and then the start/stop
button.
@Connect the AV OUT connector of the GR-C7E to the 10-pin camera connector of the second recorder using
the optional VC-V810U conversion cable.
Operation
1. Press the MONITOR
button.
10-pin camera connector
\
To AVOUT
€&
connector
VC-V810U
Conversion cable (optional)
Note:
2. Put the connected
recorder
in
the Recording Standby (Record-
Pause) mode.
@The
viewfinder's mode indica-
tion corresponds to the state of
the connected recorder.
3. Press
the start/stop
button
of
the GR-C7E to start recording.
Precautions
@Power
is not
supplied to the GR-C7E
from the
connected
VCR.
Independent
power supply is re-
quired for both the GR-C7E and the VCR.
elf you
stop recording
by pressing the GR-C7E's
start/stop button, the connected VCR
also stops in
the Pause
mode.
However,
the
pause
command
signal is not delivered to the connected VCR in the
27
following
cases and, therefore, the VCR
will start
automatically:
(1) when the GR-C7E
is switched off or its battery
becomes discharged.
(2) when the VC-V810U cable is disconnected.
Therefore,
before replacing the battery or tape for
the GR-C7E,
put the connected VCR either in the
STOP or REC LOCK mode.
Publicidad
