JVC VideoMovie GR-C7 Manual De Instrucciones página 34

35
IN CASE OF DIFFICULTY
What may initially appear to be trouble is not always a real problem. Make sure first... .
Power
No power is supplied. @{s the battery pack correctly installed?
@1s the battery pack charged?
1s the power supply unit correctly connected?
@is the POWER switch of the connected AC adapter set to ON?
Check to see if the cassette safety tab is in place. See page 5.
vw.
®|f in the manual white balance mode, check the setting of the Sgt [&
button.
Recording
Recording is impossible.
Picture colours greatly differ
from actual subject colours.
No sound is recorded with an @ls the microphone's switch set to ON?
external microphone.
Recording does not start. @ Have you pressed the REC STBY button first?
Playback
Tape is running, but no @\ls the VIDEO/TV switch of the RF unit set to VIDEO?
playback picture appears. @ls the TV receiver set to your video channel?
Noise bars appear in the ®Use the TRACKING control to reduce noise bars.
playback picture.
Playback picture is blurred or @Video heads may be dirty or worn out. For head cleaning or replace-
interrupted while TV pro- ment, consult the nearest JVC dealer.
grammes received are clear.
Tape transport
Tape stops during fast forward @ls the ''M"' indication visible in the tape counter?
or rewind, If so, press the MEMORY button to cancel the memory function.
Rewinding or fast forwarding @Check to see if the tape has already been fully wound on one reel or
is impossible. the other.
@\f this should happen when using power supply units other than the
battery pack, turn their POWER switch on and off.
With a battery pack, replace it with another charged one.
- No function is available with
more than two mode indicators
lit.
The GR-C7E is a microcomputer-controlled device. External noise and interference might prevent it from
functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC power adapter,
etc.); and then reconnect it and proceed as usual from the beginning.