Publicidad
Idiomas disponibles
Idiomas disponibles
SMA Solar Technology AG
5
Mounting
5.1
Requirements for Mounting
Requirements for the mounting location:
Danger to life due to fire or explosion
Despite careful construction, electrical devices can cause fires. This can result in death or serious
injury.
• Do not mount the product in areas containing highly flammable materials or gases.
• Do not mount the product in potentially explosive atmospheres.
☐ Installation may only be carried out in places with restricted access (e.g. private property,
company premises). Use of the product as a public charging station is not permitted.
☐ A solid, flat support surface, e.g. concrete or masonry, must be available for mounting. The
difference between the outer anchoring points must not exceed 5 mm.
☐ The support surface for installation must be made of a non-flammable material.
☐ Installation must be carried out so that the plug of the charging cable is always at a height of
0.5 m to 1.5 m above floor level.
☐ The mounting location must be suitable for the weight and dimensions of the product (see
Section 14, page 67).
☐ The mounting location must not be exposed to direct solar irradiation. If the product is
exposed to direct solar irradiation, the exterior plastic parts might age prematurely and
overheating might occur. When becoming too hot, the product reduces its power output to
avoid overheating.
☐ Mounting location must be selected so that the EV Charger and the vehicle can be connected
with the charging cable. The charging cable must not be strained, squeezed or bent.
☐ No other device may be installed under the product.
☐ The mounting location should be freely and safely accessible at all times without the need for
any auxiliary equipment (such as scaffolding or lifting platforms). Non-fulfillment of these
criteria may restrict servicing.
☐ All ambient conditions must be met (see Section 14, page 67).
Permitted and prohibited mounting positions:
☐ The product may only be mounted in a permitted position. This will ensure that no moisture can
penetrate the product.
☐ The product should be mounted such that the LED signals can be read off without difficulty.
Operating manual
WARNING
5 Mounting
EVCxx-10-BE-en-11
25
Publicidad
