Publicidad
Idiomas disponibles
Idiomas disponibles
SMA Solar Technology AG
Procedure:
1. Place the enclosure lid slightly tilted on the terminal
cover and then close it completely.
2. Tighten the screws in the order shown (TX25,
torque: 6 Nm ± 0.3 Nm). Finally, retighten the first
screw.
3. Tighten the 3 screws of the terminal cover in the
specified sequence (TX20, torque: 3.5 Nm).
4. Wrap the charging cable around the enclosure.
5. Close unused enclosure openings with cable glands.
6. Ensure that all cable glands have seal inserts and that the seal inserts have not moved.
7. Switch on the AC circuit breaker.
8. Wait until the product is in operation. The procedure takes approx. 4 minutes. Meanwhile, the
current operating state of the product is indicated by the LEDs (see Section 4.4, page 17).
9. Ensure that the charging station is in fast charging mode.
Operating manual
7 Commissioning
3 0 °
~
1
3
4
2
1
3
EVCxx-10-BE-en-11
4x
2
41
Publicidad
