Publicidad
Idiomas disponibles
Idiomas disponibles
12 Decommissioning the Product
13. Lead the AC cable out of the product through the cable gland. If necessary, loosen the swivel
nut of the cable gland.
14. With EVC22-3AC-10, remove the conductors L1, L2,
L3, N, grounding conductor and CP cable from the
terminal block for connecting of the charging cable.
With EVC7.4-1AC-10, remove the conductors L1,
N, grounding conductor and CP cable from the
terminal block for connecting of the charging cable.
Stick a flat-blade screwdriver (blade width: 3 mm)
as far as it can go into the rectangular opening via
the terminal and remove the conductors from the
terminals.
15. Lead the charging cable through the bending protection spiral and the cable gland out of the
product. If necessary, loosen the bending protection spiral.
16. Replace the enclosure lid and tighten the screws in
the sequence shown (TX25, torque: 6 Nm ±
0.3 Nm). Finally, retighten the first screw.
17. Loosen the hexagon head screw with which the mounting bracket is attached to the support
surface.
18. Slightly loosen the 2 screws for fixing the metal
brackets at the top of the product.
64
EVCxx-10-BE-en-11
SMA Solar Technology AG
EVC22-3AC-10
EVC7.4-1AC-10
1
3
4
2
Operating manual
L 1 L 2
L 3
N
P E
L 1 L 2
L 3
N
P E
4x
Publicidad
