SMA EV CHARGER 7.4 Manual De Operación página 63

SMA Solar Technology AG
6. Take the cable support sleeve out of the threaded
sleeve and remove the cable support sleeve from
the network cable.
7. Lead the network cable out of the threaded sleeve
and the swivel nut.
8. Screw the protective cap onto the network port.
9. Remove the terminal blocks for connecting the signal
source to the digital input from the port for
connecting a digital signal source.
10. Remove the conductors from the terminal blocks.
11. Lead the connection cable out of the product. If necessary, loosen the cable gland.
12. For EVC22-3AC-10, remove conductors L1, L2, L3,
N and grounding conductor from the terminal block
for connecting the utility grid. For EVC7.4-1AC-10,
remove conductors L1, N and grounding conductor
from the terminal block for connecting the utility grid.
Stick a flat-blade screwdriver (blade width: 3 mm)
as far as it can go into the rectangular opening via
the terminal and remove the conductors from the
terminals.
Operating manual
12 Decommissioning the Product
2
1
EVC22-3AC-10
L 1 L 2
L 3 N
EVC7.4-1AC-10
L 1 L 2
L 3 N
EVCxx-10-BE-en-11
N P E
N P E
63