STERWINS UP20 Instrucciones De Montaje, Utilización Y Mantenimiento página 213

4.1 UNBOXING
Unboxing instructions :
→ Wear gloves when unboxing.
→ Do not use cutter, knife, saw or any other similar tool for unboxing.
→ Carry the tool only by the handle.
→ Keep the box for further reuse (transport and storage).
→ Keep instruction manual in a dry area for further consultation.
4.2 INSTALLATION
Assemble the product stand : illustration 2.1 to 2.5
Make sure your battery isn't on your tool before manipulating it.
Place the saw on a flat, firm surface. Remove the brake. Loosen up the tensioning dial
anti-clockwise and remove dial and chain cover from the chainsaw.
Hold the guide bar guide still and fit the chain into the drive sprocket. While lining up the slot on
the guide bar with the chain tensioning bolts on the machine, on the side of the tool.
Once the chain is in place, pull the guide outwards, replace chain cover correctly and start
rotate the chain quick tesioning dialclockwise until is firmli thightened.
4.3 PREPARATION
Wear safety equipement : illustration 3.1
Before using the product, make sure to put on the following protective equipement :
→ Safety glasses
→ Face mask
→ Protective cloth
4.4 FIRST USE
WARNING! READ THE « SAFETY INSTRUCTION » SECTION AT THE
BEGINNING OF THIS MANUAL INCLUDING ALL TEXT UNDER
SUBHEADING THEREIN BEFORE USING THIS PRODUCT.
→ Earmuffs
→ Protective gloves
→ Protective overall
213
1. Hand guard Guide bar cover
2. Front finger guard
3. Oil tank
4. Safety switch
5. ON/OFF Switch
6. Saw chain
7. Guide bar
8. Head screw
9. Sprocket cover
10. Housing
→ Safety boots
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN