Bosch SHI Instrucciones De Instalación página 10

Door Panet Installation
25 _
(636 mm)
23-1/16"
(586 mm)
Figure 15
DOOR PANEL INSTALLATION
SHU ModeJs - Accessory Panet Installation
Uf y ou have an SHU modeUand have ordered an accessory
paneUkit, install the paneUprior to sliding the dishwasher
into pUace,The paneUdimensions are shown in Figure 15,
SIll Models - PaneJ Installation
SHUmodeUscome with additionaU mounting hardware and a
tempUate sheet with installation instructions, The stainUess
steeUmodels of the SHI series also come with two exten-
sion pieces, The extension pieces are used to match the
control panel height (Figure 16, "B" dimension) to the
horizontal drawer line of the cabinets, and must be
installed as shown in on the template sheet, The standard
piece is used for drawer heights up to 6" (152mm); the long
piece is used for drawer heights greater than 6" (152mm)
but 6-7/16" (164mm) or less, If your drawers are taller than
6-7/16", you can either slide the extension piece in as far
as it will go, or remove it and fit the door panel directly
below the control panel,
C
A
k. j
Figure 16
SIll/SHY Models - PaneJ Installation
SHV models come with additional mounting hardware and
a template sheet that will show you how to mount the
panel, One side of the template shows how to mount a one
piece panel; the other side shows how to mount a two
piece panel, Decide which type of installation you want
before proceeding with the installation,
Fig. 16
Dimension
SHI Only
Extension "A"
Max. _ Min.
Standard Long
"B" "C"
Maxo-Min,
11/16-5/16" 1 !/8-1!/16" 55/16 67/16-55/8
/18-Smrn) (29- 18ram) (!35mm) (164- 143turn)
Fig. 17 Panel Dimension
Dimension
20 11/16" - 25"
D (SHI) (526mrn - 635mrn)
E 27 3/16" - 30 5/16"
SHI & SHV (690mm - 770mm)
F 23 3/16" - 23 3/8"
SIll & SHV) (589mm - 594mm)