Bosch SHI Instrucciones De Instalación página 8

Plumbing Preparation/Dishwasher Preparation
Figure 8
Figure 9
r %
Figure 10
B
\
Figure 11
PLUMBING PREPARATION (continued)
Drain PJumbing
Dishwasher Connection Piece
If the dishwasher is to drain either directly into the house°
hold drain plumbing or through an air gap, install a dish-
washer connection piece under the sink, as shown in
Figure 8, letter A,
Installing an Air Gap
If local ordinances require an air gap, as shown in Figure 9,
letter B, install it according to the manufacturer's instruc-
tions,
Disposer
If a disposer is to be installed, as shown in Figure 10, letter
C, install it according to the manufacturer's instructions,
Whether the disposer is newly installed or existing, remove
the disposer's dishwasher drain connection plug,
DISHWASHER PREPARATmON
Dishwasher preparation involves four tasks:
o Installing the Mounting Brackets
o Removing the Toe Panel
o Installing the 90 ° elbow fitting
Junction Box Preparation
lnstaHing the Mounting Brackets
CAUTION:
Before installing the supplied mounting
brackets (letter E in the Materials Supplied section of this
manual), decide which method of securing the dishwasher
into its enclosure will be used, Once the mounting
brackets are installed on the dishwasher, removing them is
difficult and will damage the mounting brackets and the
dishwasher,
The dishwasher can be secured into its enclosure in two
ways:
1) Top Mount is used for countertops made of wood or
other materials that can easily drilled, Orient the mounting
brackets as shown in Figure 11, letterA, and position the
two small tabs on the mounting brackets over the two slots
on the dishwasher's front corners, Push the mounting
brackets down firmly to insert the tabs into the slots,
2) Side Mount is used for countertops made of marble,
granite, or other very hard materials that cannot be easily
drilled, Bend the mounting brackets along the small holes
and in the same direction as the two small tabs, Orient the
mounting brackets as shown in Figure 11, letter B, and
position the two small tabs on the mounting brackets over
the two slots on the dishwasher's front corners, Push the
mounting brackets down firmly to insert the tabs into the
slots,