Bosch SHI Instrucciones De Instalación página 11

Placing the Dishwasher/Securing the Dishwasher
Figure 18
A
PLACmNG THE DISHWASHER
1) Straighten and position the hot water supply line and the
electrical supply cable as shown in Figure 18 so that they
will align with their channels under the dishwasher base,
2) Position the dishwasher close enough to the enclosure
so that you can run the dishwasher drain hose to the under
sink drain connection, Make certain that the hot water
supply line and the electrical supply cable are in their
channels under the dishwasher base, as shown in Figure
19, letter A,
3) Place the dishwasher directly in front of the enclosure,
4) Perform a level check as shown in Figure 19, Adjust the
rear leveler by turning the center screw at the front of the
dishwasher, as shown in Figure 20, letter B, Turning the
screw clockwise raises the rear of the dishwasher, Adjust
the front levelers by turning them with a screwdriver, as
shown in Figure 20, letter C, Turning the levelers to the
right raises the dishwasher, if additional height is needed,
shims may be added under the leveler feet,
5) Push the dishwasher into the enclosure,
SECURING THE DmSHWASHER
Drive the mounting screws through the hoUesin the
mounting brackets, as shown in Figure 21, UetterA for Top
Mount, or as shown in Figure 21, UetterB for Side mount.
Figure 19
f
Figure 20
A
10
Figure 21