Bosch SHI Instrucciones De Instalación página 5

Enclosure Preparation
23-9/I6"
[598mm)
ENCLOSURE PREPARATmON
NOTE: This dishwasher is designed to be encbsed on the
top and both sides by standard residentiN kitchen
cabinetry,
Sebct a bcation as dose to the sink as possibb for easy
access to water suppUy and drain Hnes,
For proper dishwasher operation and appearance, ensure
that the encbsure is square and has the dimensions
shown in Figure 2,
if the dishwasher is to be installed in a corner, make sure
that there is adequate clearance to open the door, as
shown in Figure 8, letterA,
,_ WARNmNG: ELECTRICAL SHOCK/FIRE
HAZARD - Do not allow the e_ectricN and
water supply Hnee to touch. Separate
channels are provided under the
dishwasher (see page 10).
A
Countertop
Figure 3
if the enclosure requires openings for the electrical supply
cable, hot water supply line, and dishwasher drain hose,
place them within the dimensions shown by the shaded
area of Figure 4 to avoid interference with the dishwasher
frame or other components, Make the openings for the
electrical supply cable and hot water supply line 1"
(25,4mm) diameter, Make the opening for the dishwasher
drain hose 1 ol/4" (32mm) diameter, if the openings are
made through wood, sand them smooth, if the openings
are made through metal, make them large enough to
accommodate grommets or other protective sheaths with
inside diameters of 1" (25,4mm) for the electrical supply
cable and the hot water supply line, and 1ol/4" (32mm) for
the dishwasher drain hose,
i\
I\\
23-5/8"- 24-1/8"
(600mm - 613mm)
Figure 4
4