Bosch SHI Instrucciones De Instalación página 9

Figure13
Figuce 14
Dishwasher
Preparation
DmSHWASHER PREPARATmON (continued)
Removing the Toe Pane1
Regular Toe Pane!
The toe paneHis HooseHy a ttached with tape, Remove the
tape and puHH the toe paneHaway from the dishwasher, Set
the toe paneHaside, HtwHH be reinstaHHed Hater,
SHY66 and SHX99A Base and Toe PaneJ
The base and toe paneHare in pHaceon the dishwasher, but
are not attached, Remove the toe paneHfirst, as shown in
Figure 12, HetterA, then remove the base, as shown in
Figure 12, HetterB
installing the 90 ° Elbow Fitting
NOTE: The 90 ° eHbowfitting is not supplied with the
dishwasher, and must be purchased separateHy, Hf t he
dishwasher's hot water suppHyHineis to be copper tubing,
make certain the eHbow has a compression fitting,
AppHyTeflon tape or other pipe seaHant when required,
Orient the hot water suppHyconnection Hegof the eHbow
toward the channeHopening in the dishwasher base,
Junction Box Preparation
1 ) Remove junction box cover, Figure 13, by Hiftingthe
junction box cover up and off,
2) Remove the strain reHiefpilate by removing the screw at
the back of the junction box, as shown in Figure 14, Hetter
D and sHidingthe strain reHiefpilate out,
3) Set the junction box cover, strain reHiefpilate, and screw
aside, They wiHH be re-instaHHed Hater,
8