Publicidad
Idiomas disponibles
Idiomas disponibles
www.evolutionpowertools.com
Fig. 23
Fig. 24a
Fig. 24b
If adjustment is required:
Note: The Cutting Head will need to be tilted to gain access to
the 45˚ Bevel Stop Adjustment Screw.
• Loosen slightly the 45˚ Bevel Stop Adjustment Screw
locknut. (Fig. 23)
• Use a Hex Key to turn the Bevel Stop Screw clockwise or
counterclockwise as required.
• When exact alignment between the blade and Rotary Table
is achieved, tighten the locknut.
FENCE ADJUSTMENT (Fig. 24a & 24b)
The Fence is fastened to the machines base by four socket
head screws, two on either side. These Screws are located in
elongated holes, which enable the Fence to be repositioned as
required.
The Fence should be set at exactly 90˚ to a correctly installed
blade. An accurate Engineers Square (not supplied) will be
required to precisely position the Fence.
To reposition the Fence:
• Set the Rotary Table to 0˚ Mitre Angle.
• Set the Cutting Head to 0˚ Bevel Angle.
• Slightly loosen the four Fence socket head screws.
• Lower the Cutting Head to its lowest position.
• Check the alignment of the Fence with the Blade using the
Engineers Square.
• Align the Fence as necessary and then tighten the socket
head screws.
MAINTENANCE AND ADJUSTMENTS
WARNING: Ensure that the machine is disconnected from
the mains supply before any maintenance tasks or adjustments
are attempted.
Cleaning
After each use the machine should be cleaned. Remove all
sawdust etc from the visible parts of the machine with a
vacuum cleaner. A vacuum cleaner can also be connected to
the machine dust extraction port at the rear of the machine.
This should remove debris from the inside of the machine.
Never use solvents to clean plastic parts, as solvents can
damage them. Clean only with a soft slightly damp cloth.
In order to extend the service life of the tool, oil the rotary
parts once monthly. Do not oil the motor. When cleaning the
plastic do not use corrosive products.
WARNING: Water must never come into contact with the tool.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice.
19
EN
Publicidad
