Publicidad
Idiomas disponibles
Idiomas disponibles
PERFORM CUTS CORRECTLY & SAFELY
Wherever practicable always secure the work
piece to the saw table using the work clamp
where provided.
Always ensure that before each cut the mitre saw
is mounted in a stable position.
If needed the mitre saw can be mounted
on a wooden base or work bench or attached to
a mitre saw stand as detailed in this Instruction
Manual.
Long work pieces should be supported on the
work supports provided or on appropriate
additional work supports.
WARNING: If any parts are missing, do not
operate your machine until the missing parts are
replaced. Failure to follow this rule could result in
serious personal injury.
ADDITIONAL SAFETY ADVICE
CARRYING YOUR TABLE MITRE SAW
Safety Advice
• Although compact, this saw is heavy. To
reduce the risk of back injury, get competent
help whenever you have to
lift the saw.
• To reduce the risk of back injury, hold
the tool close to your body when lifting.
Bending your knees so you can lift with your
legs, not your back. Lift by using the handhold
areas at each side of the machines base.
• Never carry the Table Mitre Saw by the
power cord. Carrying the tool by the power
cord could cause damage to the insulation or
the wire connections resulting in electric shock
or fire.
• Before moving the saw tighten the mitre
and bevel locking screws to guard against
sudden unexpected movement.
• Lock the Cutting Head in its lowest position.
Ensure that the Cutting Head Locking Pin is
completely engaged in its socket.
www.evolutionpowertools.com
WARNING: Do not use the blade guard as a
'lifting point' . The power cord must be removed
from the power supply before attempting to
move the machine.
• Lock the Cutting Head in the down position
using the Cutting Head locking pin.
• Loosen the Mitre Angle Locking Screw. Turn
the table to either of its maximum settings.
• Lock the table in position using the
Locking Screw.
• Use the two carry handle cut-outs machined
into either side of the machine base, to
transport the machine.
Place the saw on a secure stationary work
surface and check the saw over carefully.
Check particularly the operation of all the
machines safety features before attempting to
operate the machine.
8
Publicidad
