Publicidad
Idiomas disponibles
Idiomas disponibles
•
The upper saw blade guard has to be
lowered over the workpiece for each cut.
•
Be sure to use a push stick when slitting
narrow workpieces smaller than 120 mm in
width or a push block when slitting narrow
workpieces smaller than 30 mm in width.
IMPORTANT: Never use this saw to make plunge
cuts.
•
Always stand to the side of the saw blade
when working with the mitre saw.
•
Make sure that off-cuts do not catch on the
saw blade crown or they may be catapulted
into the surrounding area.
•
If the sawing gap is worn, replace the table
insert.
•
To prevent injury from flying sawdust and
chips, use the saw only with a suitable
vacuum extraction system or standard
industrial vacuum cleaner.
•
Always pull the plug out of the power
socket before adjusting or servicing the
machine.
•
Give these safety regulations to all persons
who work on the machine.
•
Do not use this saw to cut fire wood.
•
Caution! Hands and fingers may be injured
on the rotating saw blade.
•
Before you use the machine for the fist time,
check that the voltage marked on the rating
plate is the same as your mains voltage.
•
If you need to use an extension cable,
make sure its conductor cross-section is big
enough for the saw's power consumption.
Minimum cross-section: 1.0 mm2.
•
If you use a cable reel, the complete cable
has to be pulled off the reel.
•
Never carry the saw by its cable.
•
Do not leave the saw in the rain and never
use it in damp or wet conditions.
•
Provide good lighting.
•
Never saw near combustible liquids or
gasses.
•
Wear suitable work clothes. Loose garments
or jewellery may become caught up in the
rotating saw blade.
•
Operators have to be at least 18 years of
age. Trainees of at least 16 years of age are
allowed to use the machine only under
supervision.
•
Keep children away from the machine when
it is connected to the power supply.
IMPORTANT:
•
Check the power cable. Never use a faulty
or damaged power cable.
•
Keep your workplace clean of wood scrap
and any unnecessary objects.
•
Persons working on the machine should
www.evolutionpowertools.com
not be distracted.
•
Note the direction of rotation of the motor
and saw blade.
•
After you have switched off the motor,
never slow down the saw blade by applying
pressure to its side.
•
Fit only blades which are well sharpened
and have no cracks or deformations.
•
The machine is to be operated only with
tools which conform with EN 847-1
•
Faulty saw blades have to be replaced
immediately.
•
Never use saw blades which do not comply
with the data specified in this manual.
•
Make sure that the arrow on the saw blade
complies with the arrow marked on the
machine.
•
Make certain that the saw blade does not
touch the turn table in any setting. To do
so, pull out the power plug and tilt the saw
blade by hand into the 45° position and
the 90° position. If necessary, re-adjust the
saw head.
•
It is imperative to make sure that all the
devices used to cover the saw blade are in
good working order.
•
Never wedge the hinged guard hood in
open position.
HEALTH ADVICE
WARNING: When using this machine, dust
particles may be produced. In some instances,
depending on the materials you are working
with, this dust can be particularly harmful. If you
suspect that paint on the surface of material
you wish to cut contains lead, seek professional
advice. Lead based paints should only be
removed by a professional and you should not
attempt to remove it yourself. Once the dust
has been deposited on surfaces, hand to mouth
contact can result in the ingestion of lead.
Exposure to even low levels of lead can cause
irreversible brain and nervous system damage.
The young and unborn children are particularly
vulnerable. You are advised to consider the risks
associated with the materials you are working
with and to reduce the risk
of exposure. As some materials can produce dust
that may be hazardous to your health,
we recommend the use of an approved face mask
with replaceable filters when using
this machine.
You should always:
• Work in a well-ventilated area.
• Work with approved safety equipment,
such as dust masks that are specially designed
to filter microscopic particles.
6
Publicidad
