J.P. Bowlin Sartorius Cubis II Manual página 761

1
1
5.2 Selecting an Installation Site
Procedure
Ensure that the installation conditions have been met (see
t
Chapter "15.2 Installation Conditions", page 79).
NOTICE Risk of damage to the power supply unit from argon! Observe
t
the instructions for using argon (see Chapter "15.3 Ambient Conditions",
page 80).
5.3 Unpacking
The device is packed in multilayer foam packaging. The device components,
e.g. the weighing pan, are inserted into the second and third layers of the
foam packaging.
The individual layers of the foam packaging must be removed one after the
other.
Procedure
Open the package.
t
Undo the tension belt.
t
Remove the top layer of foam packaging.
t
Remove the second and third layers of foam packaging.
t
Grip the device by the grooves (1) on the left and right-hand side and lift
t
the device out of the bottom layer of foam packaging.
Place the device down on a stable, completely flat surface.
t
Sartorius recommends keeping the original packaging to return the
1
t
device appropriately, e.g., for repairs.
5.4 Attaching or Removing the Operating
Display
Procedure
In order to attach the operating display to the device: Hook the
t
operating display onto the operating display holder (1).
To remove the operating display from the device: Pull the operating
t
display up off of the operating display holder.
Operating Instructions Cubis
Installation
| MCA Models 43
®