Publicidad
Idiomas disponibles
Idiomas disponibles
Interval
12 to 24 months, depending on
operating conditions
9.3
Maintenance Schedule
Component
Activity
Device
Contact Sartorius Service.
9.4
Re-starting the System
Procedure
Reinstall the removed components back onto the device (see Chapter 5,
t
page 42):
— Draft shield
— Weighing Pan and Associated Components
— Accessories
Connect the desired accessories (see Chapter 6.5, page 49).
t
Connect the device to the power supply (see Chapter 6.4, page 49).
t
9.5
Performing a Software Update
A software update can be installed (software package) from a USB mass
storage device using the device's USB-A or USB-C connection. An update
can also be carried out from a server via other connectors of the device. The
following describes the installation of a USB mass storage device, taken
from the Sartorius website.
A software update can extend or change the functionality of the device.
Sartorius recommends carrying out software updates:
— Prior to starting the software updates, save the device data to a USB
mass storage device.
— If a QAPP Center update is to be carried out in addition: Perform the
software update for the device first.
Two files are required for the software update: Firmware file with file ending
".upd", and checksum file with file ending ".upd.md5".
Execution of the software update and troubleshooting during this process
are described in the help text "Device maintenance" (for accessing help
texts, see Chapter "7.4 Using the Help Function", page 51).
Operating Instructions Cubis
Cleaning and Maintenance
Chapter, Page
| MCA Models
®
71
Publicidad
