J.P. Bowlin Sartorius Cubis II Manual página 776

System Settings
58 Operating Instructions Cubis
Enter the network printer "HOST NAME" under "IP or host". The HOST
t
NAME is specified in the network printer "Network Settings" printout.
If connection with the host name is delayed: Enter the network printer IP
t
address under "IP or host". The IP address is specified in the network
printer "Network Settings" printout.
Confirm the entries. To do this, press the [OK] button.
t
If the IP address changes depending on the DHCP network settings:
t
Enter the new IP address of the network printer again.
7.10.4 Configuring Print Profiles
Procedure
Open the "Settings / Weighing and Print Profile / YDP30" menu.
t
Edit a pre-configured print profile or create a new print profile by
t
pressing the [New] button, e.g., network printer YDP30-NET.
Follow the wizard's instructions in the operating display for more
t
settings.
Confirm the entries. To do this, press the [OK] button.
t
Add the created print profile to a task (see Chapter "8.7 Adding
t
Weighing and Print Profiles to a Task", page 63).
7.11 Downloading Additional Information
As part of the MCA firmware package on the Sartorius website, additional
information is available for the device, e.g. a description of interface
protocols, or a set of installation instructions for a website certificate. The
information is available as a PDF file, partially in English.
Procedure
Download the "Cubis
t
(www.sartorius.com).
Find the additional information you require, e.g. the description of
t
interface protocols.
| MCA Models
®
MCA Firmware" from the Sartorius website
®