J.P. Bowlin Sartorius Cubis II Manual página 807

Article
Density determination set for solids and liquids
Sartorius Wedge, software for data communication between the PC and
device
Additional operating display (second display)
Weighing table
Weighing table made from synthetic stone, with vibration dampening
Weighing table made from wood with synthetic stone
Wall console
Weighing scoop made from chrome-nickel steel,
(90 mm x 32 mm x 8 mm)
17 Sartorius Service
Sartorius Service is at your disposal for queries regarding the device. Please
visit the Sartorius website (www.sartorius.com) for information about the
service addresses, services provided, or to contact a local representative.
For inquiries about the system or when contacting Sartorius Service in the
event of a malfunction, ensure that you have the device information, e.g.,
serial number, hardware, firmware, configuration, close at hand so you can
pass it on to Sartorius Service. Consult the information on the
manufacturer's ID label and in the "Device Information" menu.
18 Conformity Documents
The attached documents declare the conformity of the device with the
designated directives or standards.
The Declaration of Conformity supplied here is for conformity-assessed
(verified) balances for use in the EEA. Please keep the enclosed Conformity
Declaration in a safe place.
19 Trademark Information
Ecolab™ Klercide is a registered trademark of Ecolab Europe GmbH.
Operating Instructions Cubis
Sartorius Service
Quantity Order Number
1 YDK03MS
1 YSW02
1 YSD01
1 YWT03
1 YWT09
1 YWT04
1 641,214
| MCA Models
®
89