J.P. Bowlin Sartorius Cubis II Manual página 763

1
5.7 Inserting the Connection Cable for Ethernet
An Ethernet connection cable can be attached to the device. The Ethernet
connection cable must be inserted into the cable channel on the side of the
device.
Material: 1 Ethernet connection cable
Procedure
Place the device on its side (see Chapter 5.5, page 44).
t
Fully press the Ethernet connection cable into the cable channel along
t
the side of the device. The Ethernet connection cable must not come
into contact with the side panels as this can cause device malfunctions.
Place the device back onto its base.
t
5.8 Positioning the Weighing Pan and
Associated Components
Procedure
Insert the base of the weighing compartment (3) into the device.
t
If there is a weighing pan with a shield plate: Place the shield plate (2)
t
onto the pan retainer in the base of the weighing compartment.
Insert the weighing pan (1) into the pan retainer.
t
If the weighing pan needs to be turned, e.g. with sample holders:
t
1
Lift the weighing pan and turn it to the left or right.
t
The weighing pan snaps into the next position of the pan retainer. This
2
y
avoids accidental turning of the weighing pan.
3
Operating Instructions Cubis
Installation
| MCA Models 45
®