Toyota Yokowo VZ-003900 Manual De Instrucciones página 26

4.3 Mounting the Bracket and Camera
Use the MOUNTING BRACKET HOLE PATTERN
•
of mounting holes to be drilled. Install the included rivet nut into the mounting
holes using the following procedure.
A. Using the
drill holes.
B. MOUNTING BRACKET HOLE PATTERN instructions.
1. Mark holes using template with a hole punch or marker.
2. Drill pilot hole with ⅛ inch drill bit.
3. Drill finished hole using
4. Clean any burrs from the finished hole after drilling.
Wireless Camera System
MOUNTING BRACKET HOLE
NOTICE: Ensure the Mounting Bracket Hole Pattern is level to
the trailer during installation. Recommend using a level and
installing while on flat, level surface.
WARNING: Edges of holes may be sharp.
on the last page to mark locations
PATTERN, mark the locations for the
/ inch drill bit.
5
16
Owner's Manual | 26