Publicidad
Idiomas disponibles
Idiomas disponibles
5.6 How To Put Camera Into Sleep Mode
1. Unplug the 12-volt power adaptor if it is connected.
2. Press
to enter settings menu, select "Camera Device Management", and
select "sleep" button present for the connected camera from the device list.
NOTE: If sleep operation is performed without disconnecting 12-volt power
adaptor, the WCS camera will not enter sleep mode.
3. Confirm putting the camera in sleep mode in the below prompt. Press "Yes" to
proceed entering the connected Wireless Camera into sleep mode.
4. Once the camera is in sleep mode it will be unable to be reconnected via the
paired device list menu. To turn the camera on again, please see instructions on
powering up in the
Wireless Camera System
camera
section.
Owner's Manual | 45
Publicidad
