EXFO FTB-1v2 Guia Del Usuario página 494

Communicating Through TCP/IP Over Telnet
Internal Commands of the TCP/IP over Telnet Protocol
Notes
482
To know the status of the modules before

terminating connections using the KILL LINS
command, you can first enter the STATUS CLIENT
command. For more information, see STATUS
CLIENT on page 483.
In the example below, two modules are connected:
LINS13 and LINS10.
To disconnect the LINS10 module used by

another session, enter the kill lins10 command. A
confirmation message is displayed once the
module is disconnected.
Enter again the STATUS CLIENT command to

confirm the termination of the module (LINS10 in
our example). Only the information of the
remaining connected client is displayed.
KILL LINS
FTB-1v2 and FTB-1v2 Pro