Maytag Precision Touch 750 Serie Guía De Uso Y Cuidado página 25

Troubleshooting
For most concerns, try these first.
Part or all of appliance does not
work.
Oven light and/or clock
does not function.
Clock, indicator words, and/or
lights operate but oven does
not heat.
Baking results are not as
expected or differ from
previous oven.
Food is not broiling properly or
smokes excessively.
Oven will not self-clean.
Oven did not clean properly.
Check
Check
Check
Check
if oven controls have been properly set.
to be sure plug is securely inserted into receptacle.
or re-set circuit breaker. Check or replace fuse.
power supply.
Check
Check
Check
Check
Check
if surface and/or oven controls have been properly set. See pages 4 & 10.
if oven door is unlocked after self-clean cycle. See page 19.
if oven is set for a delayed cook or clean program. See pages 11 & 18.
if Control Lock is activated. See page 9.
if control is in Sabbath Mode. See page 14.
• The light bulb is loose or defective.
• The oven light does not work during self-cleaning process.
• Oven may be in Sabbath Mode. See page 14.
• Oven may be set for a Cook & Hold or Delay function.
• The Control Lock may have been set. See page 9.
Make sure the oven vent has not been blocked. See page 16 for location.
Check to make sure range is level.
Temperatures often vary between a new oven and an old one. As ovens age, the oven
temperature often "drifts" and may become hotter or cooler. See page 15 for
instructions on adjusting the oven temperature. Important: It is not recommended
to adjust the temperature if only one or two recipes are in question.
• Check oven rack positions. Food may be too close to element.
• Broil element was not preheated.
• Aluminum foil was incorrectly used. Never line the broiler insert with foil.
• Oven doorwas closed during broiling. Leave the door open to the first stop position
(:about 4 inches].
• Trim excess fat from meat before broiling.
• A soiled broiler pan was used.
• Voltage in house may be low.
• Check to make sure the cycle is not set for a delayed start. See page 18.
• Check if door is closed.
• Check if control is in Sabbath Mode. See page 14.
• Oven may be over 400° F. Oven temperature must be below 400 ° F to program a
clean cycle.
• Longer cleaning time may be needed.
• Excessive spillovers, especially sugary and/or acidic foods, were not removed prior
to the self-clean cycle.
Cont.
24