Care and Cleaning
Disconnect the power supply before cleaning and maintenance.
●
Do not splash water on the units for cleaning, as electric shocks may occur.
●
Wipe the units with a dry soft cloth, or a cloth slightly moistened with water or cleaner (not with
●
volatile liquid such as thinner or gasoline).
Remove the front panel. Dip a piece of cloth into the water colder than 45 ºC and dry it. Then wipe the
dirty part of front panel.
Note: Do not immerse the front panel into water so as to protect microprocessor components and
circuit diagram on the front panel.
Note: Do not touch the fin of indoor unit during cleaning to avoid personal injury.
Take down the air filter
①
Lift up the front panel.
Pull the air filter downwards to take it off, as
shown in Fig.(a,b).
Clean the air filter
②
Use a vacuum cleaner to remove dust.
If the filters are dirty, wash them with warm water
and mild detergent.
Dry the filters in the shade.
Note: Never use water above 45 ºC to clean the air filter as it
may cause deformation or discoloration.
Reinstall the
③
Reinstall the filters along the direction of arrowhead.
Close the panel.
Cleaning the Front Panel
Cleaning the Air Filter (every 3 months)
air filter
Caution
-
-
13
Fig. (a)
Fig. (b)