Metabo HPT NT 1850DG Manual página 13

APPLICATIONS
○ Cabinet and picture frame assembly, furniture trim.
○ On-site and mobile home trim and molding.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
CAUTION
Be sure keep the fingers away from the trigger
and push lever away from the wood.
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery.
Latch
Push
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
Handle
Battery
Insert
Pull out
<UC18YKSL>
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the pilot lamp will
blink in red. (See Table 2)
WARNING
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in the figure.
Pilot lamp
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (See Table 2)
(1) Lamp indication
The indications of the pilot lamp will be as shown in
Table 2, according to the condition of the battery
charger or the battery.
Table 2: Indications of the pilot lamp
ON/OFF at 0.5 sec. intervals
Lights continuously
Lights for 1 sec. at intervals of
0.5 sec.
ON/OFF at 0.1 sec. intervals
English
Battery
Guide rail
1
Before charging *
or
Charging complete
While charging
Overheat standby *
Charging impossible *
2
3
13