Publicidad
Idiomas disponibles
Idiomas disponibles
● Keep fingers AWAY from trigger when not
driving nails to avoid accidental firing.
● Do not use the electrical cord if damaged. Have it
repaired immediately.
● Choice of triggering method is important. Please
read and understand "METHOD OF OPERATION"
found below.
● Before starting work, check the nailing operation
switching device. This metabo HPT nailer
includes a nailing operation switching device.
Before starting work, make sure that the
switching device is properly set. If the switching
device is not set properly, the nailer will not
operate correctly.
● Never place your face, hands or feet near firing
head when using.
● Do not drive nails on top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and hit
someone.
● Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
● Never use Nailer which is defective or operating
abnormally.
● Do not use Nailer as hammer.
● Remove all remaining fasteners and battery from
nailer when:
1) doing maintenance and inspection;
2) checking proper operation of push lever and
trigger;
3) attaching or removing the nose cap;
4) cleaning a jam;
5) it is not in use;
6) leaving work area;
7) moving it to another location; and
8) handing it to another person.
● Remove battery from Nailer when:
1) loading nails;
2) turning the adjuster.
Explanation of the nailing operation
○ SINGLE SEQUENTIAL ACTUATION MECHANISM:
First, press the push lever against the wood; next, pull
the trigger to drive the nail.
After nailing once, nailing will not be possible again
until the trigger is released and pressed again.
METHOD OF OPERATION
This Nailer is equipped with the push lever and does not
operate unless the push lever is depressed.
There is a method of operation to drive nails with this
Nailer.
It is:
1. Intermittent operation (Trigger fire):
WARNING
To avoid double firing or accidental firing due to
recoil.
1) Pull the trigger rapidly and firmly.
(1) Position the nail outlet on the workpiece with finger off
the trigger.
(2) Depress the push lever firmly until it is completely
depressed.
(3) Pull the trigger to drive a nail.
(4) Remove finger from the trigger and lift the tool off the
wood surface completely.
To continue nailing in a separate location, move the nailer
along the wood, repeating steps (1)–(4) as required.
NOTE
Operations (2) and (3) should be done within
4 seconds of each other. If more than 4 seconds pass
after (2) the Nailer will not work properly. If this
happens, retry from (2).
Push lever
WARNING
A nail will fire each time the trigger is depressed
as long as the push lever remains depressed.
English
(2)
Trigger
(3)
19
Publicidad
