Metabo HPT NT 1850DG Manual página 25

PROBLEM
Nailer operates, but no nail is driven.
Weak drive.
Slow to cycle.
Drives too deep.
Skipping nails.
Intermittent feed.
Nails jam.
Driven nail is bent.
CHECK METHOD
Magazine is dirty.
Check for a jam.
Driver blade worn or damaged?
Feed spring weakened or damaged?
Nail feeder damaged?
Check for proper nails.
Check position of nailing depth
adjustment adjuster.
Driver blade worn?
Damaged internal electronics.
Check position of nailing depth
adjustment adjuster.
Check for proper nails.
Nail feeder damaged?
Feed spring weakened or damaged?
Driver blade worn or damaged?
Check for proper nails.
Driver blade worn or damaged?
CORRECTION
Blow and wipe clean the magazine.
Clear a jam (See page 21).
Contact metabo HPT for inspection.
Replace feed spring.
Replace nail feeder.
Use only recommended nails.
Readjust according to page 20.
Contact metabo HPT for inspection.
Contact metabo HPT for inspection.
Readjust according to page 20.
Use only recommended nails.
Replace nail feeder.
Replace feed spring.
Contact metabo HPT for inspection.
Use only recommended nails.
Contact metabo HPT for inspection.
English
25