Walter SURFOX MAX Serie Manual Del Usuario página 17

Installation of brush adaptor / insert
4.2.
When installing the adaptor or the inserts, the DW wand must not be connected to the device.
• Take the brush adaptor
54-B 149
• In the back of the adaptor (or insert) there are the two
countersinks (A) where the DW wand coupling set screws
will be tightened.
• Place the adaptor (or insert) on the DW wand coupling
and tighten the two set screws with a 2.5 mm hex key (B)
(included); make sure the set screws are properly aligned
with the countersinks (A).
or the desired insert.
B
A
17